Sump Pump Systems

Model 53 Cast Iron Series

  • Non-Clogging vortex impeller.
  • Float operated, submersible (NEMA 6) 2-pole mechanical switch & variable level long cycle systems available.
  • UL Listed 3-wire cord plug; 9 ft. standard for automatic, 15 ft. standard for nonautomatic.
  • Corrosion resistant powder coated epoxy finish.
  • No sheet metal parts to rust or corrode.
  • Stainless steel screws, switch arm, guard and handle.
  • No screens to clog.
  • Watertight neoprene ring between motor and pump housing.
  • Solid buoyant polypropylene float.
  • Motor - 60 Hz, 1550 RPM, oil-filled, hermetically sealed, automatic reset thermal overload protected.
  • Upper and lower sleeve bearings running in bath of oil.
  • Entire unit pressure tested after assembly.
  • Carbon and ceramic shaft seal.
  • Maximum temperature for effluent or dewatering - 130°F (54°C).
  • Passes 1/2" inch spherical solids.
  • 1 1/2" NPT Discharge.
  • On point - 7 1/4";
  • Off point - 3".
  • Major width - 10 3/32".
  • Height - 10 1/16".
  • Cast iron switch case, motor & pump housing.
  • Glass-filled polypropylene base.
  • Engineered, glass-filled, plastic impeller with metal insert.
  • Stainless steel guard & handle.
  • Bearing - lower & upper oil fed cast iron.


Note: The sizing of effluent systems normally requires variable level float(s) controls and properly sized basins to achieve required pumping cycles or dosing timers with non-automatic pumps.

 

Model 98 Cast Iron Series

  • Non-clogging engineered plastic vortex impeller design.
  • Corrosion resistant powder coated epoxy finish.
  • Durable cast construction. Cast switch case, motor, pump housing and base. No sheet metal parts to rust or corrode.
  • Castings - All cast iron class 25-30 25000# tensile strength.
  • Stainless steel screws, guard, handle, arm and seal assembly.
  • Float operated submersible (NEMA 6) 2-pole mechanical switch.
  • Motor - Permanent split capacitor, 60 Hz, 1725 RPM, oil-filled, thermetically sealed, automatic reset thermal overload protection.
  • Bearings - Upper & lower oil fed cast iron.
  • Carbon and ceramic shaft seal.
  • Entire unit pressure tested after assembly.
  • Watertight neoprene “” ring between motor and pump housing.
  • Maximum temperature for effluent or dewatering 130°F - 54°C.
  • Passes ½ inch spherical solids.
  • No screens to clog.
  • Standard cord length 15 ft. (UL Listed).
  • 1½” NPT Discharge (1½” X 2” PVC Adapter included with BN & BE Models).
  • On point - 9½”
  • Off point - 3”
  • Major width - 10 1/8”
  • Height - 12”


Note: The sizing of effluent systems normally requires variable level float(s) controls and properly sized basins to achieve required pumping cycles or dosing timers with non-automatic pumps.